CLEANING OF DRY SYRUP POWDER FILLING MACHINE 1. Put off the electric connections. 2. Dismantle the nozzle, hopper, auger and the main shaft and transfer them to the equipment cleaning room. 3. Wash all the parts with hot water and a soap solution (10% soap and 1% disinfectant) ning soft nylon wire brush. 4. … Read more
CLEANING OF DOUBLE CONE BLENDER 1.Caution :Disconnect the equipment from electrical main supply. 2. Set the position of the blender vertical-butterfly valve facing the floor A ) PROCEDURE FOR PRODUCT TO PRODUCT CHANGEOVER 1. Dismantling- a. Remove the safety guard of the blender b. Remove the circular lid and gasket by unclamping wing nuts. … Read more
CLEANING OF CONVENTIONAL COATING PAN Coating pan 1. As soon as the coating operation is over, remove the coated tablets in suitable contains Remove the dry powder from the pan, if any. 2. Pour approximately 20 liters of hot water (80-85 °C) into the pan and allow the pan to r for about 10 minutes. … Read more
Cleaning of capsule inspection cum polishing machine PROCEDURE FOR PRODUCT TO PRODUCT CHANGEOVER 1. Dedusting external surfaces Using cleaned nylon brush and vacuum cleaner. Remove the filter bag of the vacuum can placed below the machine. 2. Dismantling-Remove: a. Hopper assembly with sieves and trays. b. Conveyor belt with guides and slitter guards. … Read more
sop for cleaning of autoloader CLEANING OF AUTOLOADER CAUTION-Switch off the electrical mains of the machine CLEANING OF AUTOLOADER CAUTION-Switch off the electrical mains of the machine A. PROCEDURE FOR PRODUCT TO PRODUCT CHANGEOVER 1. Dedusting external surfaces Use clean nylon brush and wipe with clean dry lint free duster. 2 Dismantling (a) back and … Read more
CLEANING AND ASSEMBLY OF STRIP SEALING MACHINE OBJECTIVE To exclude the chances of product mix up, it is essential that the strip sealing machine is thoroughly cleaned after the strip sealing operation on particular product is over. Also the wall surfaces and the surfaces of all other equipment in the strip sealing room … Read more
sop for cleaning and assembly of compression machine PROCEDURE As soon as the compression of a particular batch is over, clean the entire exterior of the machine as well as the room. Following procedure will be adhered to: (1) Disconnect the electric supply (ii) Dismantle carefully the following parts • Feed hoppers • Acrylic … Read more
sop for checking punch height A. FOR NEW PUNCH SETS 1. Take the punch box in spare parts room. 2. Clean the punches as per SOP. 3. Assemble the punch height checking equipment. 4. Clean the platform of punch height checking equipment. 5. Place the standard punch (supplied along with equipment) on platform and adjust … Read more
sop for charge hand over between the shifts 1, FROM CURRENT SHIFT TO NEXT SHIFT • Following are the instructions to be given by current shift officer to the next shift officer for charge • hand over. • Name of product/lot/workmen on each machine. • Status of each machine whether under changeover or under … Read more
sop for handling of acids 1.0 OBJECTIVE: To lay down the procedure for handling of acids in laboratory. 2.0 SCOPE: This SOP is applicable to Quality Control Department of abc pharma. 3.0 RESPONSIBILITY: 3.1 Chemist – Quality Control. 3.2 Executive – Quality Control. 4.0 ACCOUNTABILITY: 4.1 Head – Quality Control 5.0 PROCEDURE: 5.1 … Read more